Filter
Top Products
33
GB
Problem
v
,
V
, B and b buttons do not work
in PAP mode.
Remote control does not function.
The standby indicator on the TV
flashes.
The lamp indicator
on front of the
TV set is lit.
Problem
If no picture is displayed and the NO
SYNC message appears on the
screen.
Some picture lines are not correctly
displayed.
Blurred letters or vertical lines or
shade or noise is visible in detailed
patterns.
The Startup or the Setting screens of
the Personal Computer cannot be
displayed.
Solution
• PAP navigation is only possible in TV mode, please check that Media
Selector is set to TV.
• Be sure you are ponting it towards the remote control receiver (see page 8).
• Check that the Media Selector on the remote control is set to the device
you are using (VCR, TV or DVD).
• If the remote control does not operate the VCR or DVD even when the
Media Selector has been set correctly. Enter the necessary code set as
explained on page 26.
• Replace the batteries.
• Contact your nearest Sony service centre.
• Turn the TV off. Turn the TV on again, if the lamp indicator is still lit then
replace the internal lamp. For details refer to pages 28 and 29.
Solution
• Check that the video signal cable is properly connected and all plugs are
firmly seated in their sockets.
• Check that the 15-Dsub video input connector’s pins are not bent or pushed
in.
Personal Computer output format
• Check that the output signal format of the Personal computer is set to the
corresponding format for the television. In case it is not, adjust the
resolution and refresh rate to the corresponding signal (refer to page 31).
Problems caused by the connected computer
• The computer is in power saving mode. Try pressing any key on the
computer keyboard.
• Check that the computer’s power is "on".
• Check that the computer’s keyboard is properly connected.
• Check that the graphic board is completely seated in the proper bus slot.
• In case of a notebook PC, check that the monitor signal is set to the external
output, and the signal is correctly output to the television.
• Using the menu system, select the "Picture Adjustment" menu and adjust
the "Lines Correction" option between -20 and +20 (see page 13).
• Small letters, check or mesh patterns cannot be accurately displayed. In
this case, increase the size of the fonts and/or reduce the mesh pattern
brightness.
• Depending on the PC, the Startup or Setting screens may not be displayed
due to the output format of the image. These screens can be displayed on
the monitor of the Personal Computer.
• If you continue to experience problems, have your TV serviced by qualified personnel.
• Never open the casing yourself.
Additional Information
Personal Computer