]]]]]]]]]]]J'lBa icSet Up
Using the Remote Control
Inserting the batteries
Insert two size AA (R6) batteries (supplied)
by matching the + and on the batteries to
the diagram inside the remote control's
battery compartment.
Notes:
• Remove the batteries to avoid damage
from possible battery leakage whenever
you anticipate that the remote control
will not be used for an extended period.
• Handle the remote control with care.
Avoid dropping it, getting it wet, or
placing it in direct sunlight, near a heater
or where the humidity is high.
• Your remote control can be programmed to
operate most video equipment.
(see "Operating Video Equipment" on
page 47)
Setting Up the Projection TV
Automatically
The AUTO SET UP feature will allow you to
set the on-screen language and set all
receivable channels.
The AUTO SET UP feature does not apply for
tnstallatians that use a cable box for all channel
selection.
You can also set up the wojectian TV manually,
(see Using the Channel Set Up menu on pages
30 and 31)
Notes:
• Before you perform AUTO SET LIPagain,
make sure that the input from ANT (not
AUX) is selected By pressing ANT until
"AUX" does not appear next to the
channel number.
Perform this function during the day, with
the antenna and/or cable properly
connected, to ensure that all available
channels wtfl be broadcasting and
receivable.
• When you perform AUTO SET UP, all the
settings in the Video, and Audio menus
are reset to the factory settings.
Using the buttons on the front panel of the
projection TV:
_F_WNIDEQ -- VQLUM_ + _ _HANN_L+ POWER m_
[] [] [I [] [] [I ,
1 Press POWER to turn on the projection
TV.
Press SET UP inside the drop-down panel
on the projection TV and the AUTO SET
UP screen appears.
POWER _rT_4fi_P : /_H+]
F_arl_ai_ : /VKaL +]
AUtO _i !Ip : [VOL /
F_ratpl_a _n_
Ih_ anl_mla
I_ /SEF UP] {o_it,
2 Press CHANNEL + to select English,
CHANNEL toselect Espafiol or
VOLUME + to select Frangais.
The screen wtfl change to reflect your
choice.
-- VOLUME ÷ -- CHANNEL+ _n_li_P" : ICH _]
Auto 8_1 !1_ : [VOL /
a_na