Filter
Top Products
24
-EN
Getting Started
Setting cable TV on or off
If you have connected the projection TV to a cable TV
system, set CABLE to ON (the factory setting). If not,
set CABLE to OFF.
You do not have to do this procedure if you perform
AUTO SET UP (page 21). Do this procedure only when
you want to set it manually.
1 Press MENU.
2 Press V or v to select , and press .
3 Set CABLE to ON or OFF:
(1) Press V or v to move the cursor (z) to CABLE,
and press .
(2) Press V or v to select ON or OFF, and press .
4 Press MENU to return to the original screen.
Note
• If CABLE appears in gray, the projection TV is set to a video
input and you cannot select CABLE. Press ANT so that a
channel number appears.
4 Press V or v to move the cursor (z) to the
symbol showing the line you want to
adjust, and press .
+RED : Red vertical and horizontal line (left/right/up/
down adjustment)
+BLUE :Blue vertical and horizontal line (left/right/up/
down adjustment)
5 Press V, B, v, or b to move the line until it
converges with the center green line, and
press .
6 Repeat steps 4 and 5 to adjust the other
lines until all three lines converge and are
seen as a white cross.
7 Press MENU to return to the original screen.
SET UP
CHANNEL ERASE/ADD
CHANNEL CAPTION
CHANNEL BLOCK
FAVORITE CHANNEL
CABLE : OFF
AUTO PROGRAM
CC
CONVERGENCE
MENU
VIDEO LABEL
LANGUAGE : ENGLISH
Use
Exit
MENU
RED
BLUE
MENU
CONVERGENCE
+
+
Use
Ex
MENU
it
RETURN
Use
Ex
MENU
it
RED
BLUE
MENU
CONVERGENCE
+
+
RETURN
R
G
B
B
G+R
To move Press
Up V
Down v
Right b
Left B