Filter
Top Products
– 28 –
KV-ES29M90
RM-916
43
Additional Information
Additional Information
Self-diagnosis function
Your TV is equipped with a self-diagnosis function. If there is a
problem with your TV, the 1 (standby) indicator flashes red. The
number of times the 1 indicator flashes indicates the possible
causes.
1
Check that the 1 indicator flashes red a number of times between 3-second
intervals.
2
Count the number of times the 1 indicator flashes.
3
Press ! (main power) to turn off your TV.
4
Inform your nearest Sony service center about the number of times the
1 indicator flashed.
Be sure to note the model name and serial number located on the rear of
your TV.
Front of TV
1
indicator
U
Additional Information
44
Additional Information
• Check the antenna cable and
connection on the TV, VCR and at the
wall.
• Press the PRESET button to display
the “MANUAL PROGRAM
” menu
and preset the channel again.
• Check the antenna type (VHF/UHF).
Contact a Sony dealer for advice.
• Adjust the antenna direction. Contact
a Sony dealer for advice.
• Try using a booster.
• Press the PRESET button to display
the“MANUAL PROGRAM
” menu.
Then, select “
SENS: LOW”.
• Turn off or disconnect the booster if it
is in use.
• If the sound of all the channels are noisy,
display the “CH PRESET” menu and
select “AUTO PROGRAM” to pr
eset the
channels again.
• If the sound of some channels is noisy,
select the channel, then display the
“CH PRESET” menu and select the
appropriate TV system (
“TV SYS”).
• Set “DIGITAL IN: OFF” in the “A/V
CONTROL” menu and connect
L
and R (component video input) on your
TV to receive analog audio signals.
• Check the power cord, antenna and
the VCR connections.
• Press I/1 (power).
• Press U (main power) on the TV to
turn off the TV for about five
seconds, then turn it on again.
Troubleshooting
If you have any problem while viewing your TV, please check the following
troubleshooting guide. If the problem persists, contact your Sony dealer.
Possible cause
Symptom
Solutions
Snowy picture
Noisy sound
Distorted picture
Noisy sound
Good picture
Noisy sound
No picture
No sound
Page
4
41
–
–
–
42
–
40
41
7, 32
4
10
11
• The connection is
loose or the cable is
damaged.
• Channel presetting
is inappropriate or
incomplete.
• The antenna type is
inappropriate.
• The antenna
direction needs
adjustment.
• Signal transmission
is low.
• Broadcast signals
are too strong.
• The TV system
setting is
inappropriate.
• The digital audio
signal is
inappropriate.
• The power cord,
antenna or VCR is
not connected.
• The TV is not turned
on.