Filter
Top Products
TELLITE RECEIVER
GB-19
1.5 Manual Scanning
To tune-in new channels and weak signals, the STB has been
provided with the option "Manual Scanning" where the
channel data can be entered by the user.
After selecting the "5. Manual Scanning" from the Installation
Menu, the following screen will be displayed:
● Select the target satellite for manual search.
● Load a transponder.
This option will enable the user to load any transponder
from the preprogrammed list available within the receiver.
NNoottee : Especially on New tranpsonder at Load TR,
this new transponder can be added into
transponder list so that you can use it on Auto
Scanning later, only if at least one channel is found
with this new transponder. In order to save it, press key.
● Input the frequency of the transponder you want to find.
● Input the symbol rate of the transponder you want to find.
● Select the FEC(Forward Error Correction)of the transponder you want to find.
You can select the value of 1/2, 2/3, 3/4, 5/6, 7/8 or Auto.
● Select the polarization of the transponder you want to find.
(Horizontal/Vertical/Circular Left/Circular Right)
In the case of horizontal, 18V and in the case of vertical, 13V are output through LNB line.
● Select Scan Mode “All” or “Only Free”.
● Set "Yes" on Network Search. You can get more channels from transponder using the homing
transponder. Additionally, you can get 'Provider Name' on the screen.
● Select PID searching “Yes”. You can manually search by entering individual PID
(Packet Identifier)(Video/Audio/PCR) values.
● After select option, press key to start the scan process.
OPERATING THE RECEIVER
DSR 9500/9510 2.28 3/5/03 3:33 PM Page 19