Filter
Top Products
GB-28
DIGITAL SATELLIT
4.5 System Information
If you have to contact your service provider or a service center
they might ask for information available from this menu.
Place the cursor on this sub menu and press key.
The following will be the on-screen display.
4.6 Software Upgrade
You can download and upgrade the software of this STB through
ASTRA and Hotbird satellite when the new software is released.
During downloading don’t turn off the STB.
If there is a new version of software to download, you are asked
if you will update or not.
If you press key, the update starts right away.
In case update is impossible, you get this message
"You can’t update software!" Or in case you don’t need to
update, "You don’t need to update software!" will be displayed.
If you get information that a Transponder is changed to different
one for Samsung software, you should select “User Advanced Mode”
at Menu mode by using Vol-/Vol+ key.
Then you should set exact parameters for the new transponder for Samsung.
4.7 Copy Channel Data
If you want to copy the channel data from one receiver
to another, please follow the instruction below.
Please make your own channel data, such as favorite
& lock channel with your own master box.
Then take your master box when you install another box.
1. Plug on both master & slave receivers
2. Master Box(Installed Box) : Stand-by Mode
3. Slave Box(Installing Box) : Menu Mode
4. Connect 2 Boxes with RS232 serial cable
(Both end should have male connector)
5. Select '4. System Setup'
6. Press '7' key on RCU
7. Press 'OK' to start channel data copy
NNoottee : Use this function after removing SMART CARD or CAM modules.
OPERATING THE RECEIVER
DSR 9500/9510 2.28 3/5/03 3:33 PM Page 28