Filter
Top Products
15 (GB)
Connections
Within 10 mm (
13
/32 inch)
Within 10 mm (
13
/32 inch)
When attaching to the cables
When you connect a cable to any of the terminals
listed below, attach the ferrite core provided before
using the cable.
AUDIO (INPUT1)
AUDIO (INPUT2)
AUDIO OUT
REMOTE
Y/C IN (VIDEO)
AUDIO IN (VIDEO)
1 Attach the ferrite core (black) to the end of the
cable closer to the PFM-42B2/42B2E, closing it
firmly until your hear it click.
2 Wind the stopper round the cord so that the ferrite
core does not slide.
3 Tighten the stopper and cut the surplus.
Notes
•When you connect this unit to various pieces of
equipment using the RGB/YUV connectors, use the
specified cable.
SMF-400 (D-Sub 15P - 5 BNC)
SMF-410 (D-Sub 15P - D-Sub 15P)
•You are cautioned that this unit will not be in
compliance with the EMC limits unless the ferrite
core is installed on the interconnecting wire.
Connection Example
Before you start
• First make sure that the power to each piece of
equipment is turned off.
•Use connecting cables suitable for the equipment to
be connected.
• The cable connectors should be fully inserted into
the jacks. A loose connection may cause hum and
other noise.
• To disconnect the cable, pull it out by grasping the
plug. Never pull the cable itself.
•Refer to the instruction manual of the equipment to
be connected.
• Insert the plug securely into the AC IN socket.
•Use one of the two AC plug holders (supplied) that
will securely hold the AC plug.