Sony PFM-42B2E Flat Panel Television User Manual


 
44 (GB)
3 Press v / V to set OSD to OFF and press ENTER.
The serial remote data is not shown.
To display the serial remote data
Set OSD to ON in step 3 above.
The factory default is ON.
Setting the NETWORK
ADAPTOR (PFM-42B2/42B2E
only)
Sets the network adaptor.
Setting the power supply to the
Network Adaptor
The power is supplied to the Network Adaptor even if
the system is in the standby mode.
You can disable the power supply in the standby
mode as follows:
1 Press MENU.
The main menu appears on the display panel.
ENTER
MENU
MA I N MENU
INPUT SELECT
PIC CONTROL
PIC SIZE
CONF I G
MEMORY
REMOTE
STATUS
SELECT SET END
2 Press v / V to move the cursor (B) to “CONFIG”
and press ENTER.
The CONFIG (1/2) menu appears on the display
panel.
ENTER
MENU
CONF I G( 1/2)
DISPLAY : ON
W-VGA : OFF
CLOSED CAPTION: OFF
COLOR SYSTEM:AUTO
SCREEN F I LL :CENTER
POWER CONTROL
SCREEN SAVER
SELECT SET END
YUV LEVEL : SMPTE
Setting the SERIAL REMOTE (PFM-42B2/42B2E only) / Setting the NETWORK ADAPTOR (PFM-42B2/42B2E only)
3 Press v / V to move the cursor (B) to
“NETWORK ADAPTOR” on the CONFIG (2/2)
menu and press ENTER.
The following menu appears on the display panel.
ENTER
MENU
NETWORK ADAPTOR
STBY POWER : ON
SELECT SET END
R ESE T
4 Press v / V to move the cursor (B) to “STBY
POWER” and press ENTER.
The following menu appears on the display panel.
STBY POWER : ON
5 Press v / V to set STBY POWER to OFF and
press ENTER.
If the system is in the standby mode, the power is
not supplied to the Network Adaptor.
To supply the power
Set STBY POWER to ON in step 5 above.
The factory default is ON.
If the screen freezes when you use
the Network Adaptor
Reset the screen as follows: