Filter
Top Products
86
Basic editing
Master Page : Left
filename[010addo.fm] model name1[SLV-SE610A/E] model name2[SLV-SE710D/E]
model name3[SLV-SX710D/E] model name4[SLV-SX717D/E]
model name5[SLV-SE810D/E] model name6[SLV-SX810D]
[3-065-674-E1 (1)]
Basic editing
when recording on this VCR
Before you start editing
• Turn on your TV and set it to the video
channel.
• Press INPUT SELECT to display the
connected line in the display window.
• Press SP/LP to select the tape speed, SP or LP.
• On this VCR, set EDIT to ON in the
OPTIONS-1 menu. If the other VCR has a
similar function, turn it on as well.
To stop editing
Press the x (stop) buttons on both VCRs.
Tip
• To cut out unwanted scenes while editing, press X (pause) on this VCR when an
unwanted scene begins. When it ends, press X (pause) again to resume recording.
Note
• If you start editing following the procedure above, the VCR won’t start recording
with the OPC function. To record a tape with the OPC function, press z REC
again during recording pause in step 3 so the VCR analyses the tape. Then, press
X (pause) after
the OPC indicator stops flashing to start recording. If you press X
(pause) before the OPC indicator stops flashing, the OPC function is cancelled.
1
Insert a source tape with its safety tab removed into the other (playback)
VCR. Search for the point to start playback and set it to playback pause.
2
Insert a tape with its safety tab in place into this (recording) VCR.
Search for the point to start recording and press X (pause).
3
Press z REConthisVCRtosetittorecordingpause.
4
To start editing, press the X (pause) buttons on both VCRs at the same
time.
X
z REC