Filter
Top Products
11
Connecting Your TV
Connecting a TV, VCR, and Cable Box
Use this connection if you subscribe to a cable system that scrambles some channels (pay channels), but
not all of them. This setup allows you to use the remote control to:
❏ change channels through your cable box or VCR when you are receiving a scrambled signal
❏ change channels through your TV
This connection also allows you to use the PIP feature when you are viewing unscrambled channels
coming directly into your TV from your cable. Scrambled signals coming through the cable box cannot
be viewed in PIP. For more information on the PIP feature, see page 20.
1 Connect the single input jack of the splitter to your incoming cable connection.
2 Using a coaxial cable (not supplied), connect the two output jacks of the splitter to:
a) the IN jack on your cable box, and
b) the VHF/UHF jack on the TV.
3 Using a coaxial cable (not supplied), connect the OUT jack on your cable box to the IN jack on
your VCR.
✍ If you will be controlling all channel selections through your cable box, you should consider using the
Channel Fix feature to set your TV to channel 3 or 4 (see page 27).
✍ You can use the button to switch between the VHF/UHF and VIDEO inputs.
1
3
4
VCR
Rear of TV
2a
1
Optional connection
Video (yellow)
Audio L (white)
Audio R (red)
Cable Box
Cable
3
2b
Splitter