Filter
Top Products
Connecting and Setting Up the DTV
30
Setting Up the DTV Automatically
The first time you turn on the DTV, a series of screens guide you
through the initial setup of the DTV. During this setup, you are
prompted to set the clock and start Auto Program, which searches for
and stores a list of analog and digital channels you are receiving for
VHF/UHF and CABLE inputs.
1
Press
POWER
to turn on the DTV and display the Welcome screen.
2
Press to continue Setup. The set clock screen appears.
3
Move the joystick
V
and
v
to set the current day and time (hour,
minute, and AM/PM). Press or move the joystick
b
to confirm
each setting and move to the next setting. Move the joystick
B
to
go back to the previous setting.
4
After you’ve set the clock, move the joystick
b
to highlight
Next
and press
to continue Setup. The Auto Program screen
appears.
5
To start Auto Program, press to select
Auto Program
.TheDTV
automatically creates a channel list of analog and digital
channels. (This may take a few minutes.)
6
When the channel list is complete, a Congratulations screen
appears.
To see a short demonstration of the features of the DTV, press
to select
Demo.
A self-running introduction to the features of the
DTV begins. To exit the demo at any time, press any button on
theremotecontrol(orfrontpanel).
To skip the demo and exit Setup, move the joystick
b
to highlight
Done
and press
.
✍
Be sure to complete all connections before turning on the DTV the first time.
The initial setup screens appear
only after turning on the DTV the
first time, or after selecting Factory
Reset in the Setup menu (pag e58).
If you need to set the clock at a
later time, press the TIMER button
on the remote control (see
page 43).
You can also run Auto Program at
any time from the Channel Setup
menu (see page 52).
z
to come
You can run the
demonstration again by
selecting Demo from the Setup
menu (see pages 58 to 60).
z