Filter
Top Products
DVR-4CF
10
7. OPERATING PROCEDURE
7.1 Power On
Each time after power on, DVR will auto-detect its peripherals (self-testing, warm-up,
auto detects the hard disk and starts CF-card testing, and etc.)
The system will detect the video input and judge whether the video system is
NTSC or PAL. When video input is unable to be detected (VIDEO LOSS), the system
will send out an alarm, press-on any button to stop the alarm (it will not affect the
actual recording).
7.2 Monitoring Mode
This mode is a default for our system after power on. Under this mode, system
supports live view for monitoring. Press《REC》button, the system enters the record
mode, press《PLAY》button to start playback, press《MENU》button to enter the menu
setup display. During record or playback, press《STOP》button to stop the current
activity and returns to monitoring mode. Under main menu, press《MENU》 to return
to monitoring mode.
During playback, press《STOP》button to return to monitoring mode. Press again
to change the speed (FF1, FF2 or FF3), or press《REW》button to start reverse
playback.
~ To reset (under quad or single display), press《PAUSE》button 5 times, the
message《ALL SETTING DATA IS INITIALIZED.》will be displayed by flashing 3 times,
and after reset the password will be set as default value (111111).
~ When reset procedure has been completed, the message“DVR RESET
COMPLETED. TURN OFF AND ON THE DVR＂will be displayed, then
please restart the DVR.