Filter
Top Products
SunbriteTV Veranda 4k Operators Manual
Page 49
Using LINK Operation
CONTROLLING HDMI EQUIPMENT USING LINK OPERATION
WHAT’S LINK OPERATION?
• Using the HDMI CEC (Consumer Electronics Control) protocol, with LINK Operation you can interactively operate compatible
system equipment (Blu-ray disc equipment, AV amplier, DVD).
• To access this function: System Operation > Initial Setup > Input Settings > Link Setup > Link Operation.
NOTE
• For connecting the TV to LINK-compatible equipment, use commercially available cables.
• Point the remote control toward the TV, not to connected HDMI equipment.
• Video noise may occur depending on the type of HDMI cable used. Make sure to use an HDMI-certied cable.
• Up to 3 pieces of HDMI recording equipment and one AV amplier can be connected using this system.
• These operations aect the HDMI equipment selected as the current input source. If the equipment does not operate, turn
on the equipment and select the appropriate input source using INPUT.
• The LINK feature may not operate properly when an HDMI splitter or AV selector unit is used. These devices may cause
interruptions to the image and/or sound.
Connected LINK-compatible devices can be operated without changing the settings of the remote control unit.
Control the Link-Compatible Audio System
Set the volume of LINK-compatible audio system.
NOTE
• The steps in "LINK Setup" on page 38 need to be completed beforehand.
• Refer to this operation manual and the operation manual of the LINK device to be used with this TV.