Swann SW242-4SN DVR User Manual


 
9
6.3 Camera Setup
Note: If a camera channel is set to off it will not record (Refer to 6.4 Record Setup)
6.4 Record Setup
6.5 Record Frame rate
Press , , or button to select a channel, and then press [SEL] to increase the
value or press [STOP] to reduce the value.
Note: Higher frame rate shows smooth images but requires more hard drive space.
Camera Setup allows you to turn
cameras on or off.
Press , , or button to select a
channel and then press [SEL] to modify the
setting ON or OFF.
Record Setup allows you to set up
recording channels.
Press , , or button to select a
channel, and then press [SEL] to modify the
setting to ON or OFF.
If a channel is disabled in Camera
Setup, it will not record and the DVR will
display “NOCAM” on screen.
The total frame rate is 50fps (PAL) or
60fps (NTSC). If the sum of the frame rate
you select for all cameras is greater than
50fps (PAL) / 60fps (NTSC), the DVR will
automatically adjust the largest frame rate
value to a smaller value.