Filter
Top Products
Introduction
15
Monitors
The main monitor displays the far-end and near-end videoconferencing sites in addition to the
menus and video from connected video sources.
Note that the TANDBERG 6000 MXP Profile is shipped with different monitors depending on
product variants; there are two different variants of the system: 43”, which has a 43” monitor and
the 50” variant, which has a 50” monitor. Hence, the pictures/drawings used in this manual might
differ from the actual monitor model shipped with the system.
Codec
The codec is the heart of the system. Its main task is the compression of outgoing video, audio
and data, the transmission of this information to the far end, and the decompression of the
incoming information. The name codec comes from a combination of the two words compression
and decompression.
Column and Base
The Roll About system is easily movable due to large wheels and handles, at the back of the
monitor. The codec is located inside the bracket assembly behind the monitor. Inside the column
assembly, there is room for additional equipment, e.g. a VCR or a DVD player.
Remote Control
The remote control is used to control all functions of the system. If the screen saver is activated
(black monitor), touching the remote control will automatically wake up the system. The remote
control uses 4 AAA batteries. The system will tell you when batteries are running low. Change the
batteries at the back of the remote control.
The reach of the remote control signal is 20 meters (65 ft). For users sitting in an open plan office,
this can cause problems. Use the little, white switch placed in the batteries compartment to
change the reach of the signal from 20 meters to 2 meters (6.5 ft). This will prevent you from
unintentionally controlling another video system, when you control your own system.