Filter
Top Products
TANDBERG 7000 MXP
viii
Operator Safety Summary
Operator Safety Summary
For your protection please read these safety instructions completely before you connect the
equipment to the power source. Carefully observe all warnings, precautions and instructions both
on the apparatus and in these operating instructions.
Keep this manual for future reference.
Water and Moisture
• Do not operate the apparatus under or near water - for example near a bathtub, kitchen sink,
or laundry tub, in a wet basement, near a swimming pool or in other areas with high humidity.
• Never install jacks for communication cables in wet locations unless the jack is specifically
designed for wet locations.
• Do not touch the product with wet hands.
Cleaning
• Unplug the apparatus from communication lines, mains power-outlet or any power source
before cleaning or polishing. Do not use liquid cleaners or aerosol cleaners. Use a lint-free
cloth lightly moistened with water for cleaning the exterior of the apparatus.
• Unplug the apparatus from communication lines before cleaning or polishing. Do not use
liquid cleaners or aerosol cleaners. Use a lint-free cloth lightly moistened with water for
cleaning the exterior of the apparatus.
Ventilation
• Do not block any of the ventilation openings of the apparatus. Never cover the slots and
openings with a cloth or other material. Never install the apparatus near heat sources such as
radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.
• Do not place the product in direct sunlight or close to a surface directly heated by the sun.
Lightning
• Never use this apparatus, or connect/disconnect communication cables or power cables
during lightning storms.
Dust
• Do not operate the apparatus in areas with high concentration of dust
Vibration
• Do not operate the apparatus in areas with vibration or place it on an unstable surface.
Power connection and Hazardous voltage
• The product may have hazardous voltage inside. Never attempt to open this product, or any
peripherals connected to the product, where this action requires a tool.
• This product should always be powered from an earthed power outlet.
• Never connect attached power supply cord to other products.
• In case any parts of the product has visual damage never attempt to connect mains power, or
any other power source, before consulting service personnel