Tascam DV-D6500 DVD Player User Manual


 
Getting started
11
Getting started
You can operate your TV from the remote control unit.
Setting the remote control signal for
operating your TV
1
Set the TV - DVD switch to "TV".
2
Hold down TV/VIDEO - CANCEL until step 4 is
finished.
3
Enter the manufacturer code of your TV listed below
by using the numeric buttons (0 through 9).
Example:
To enter the manufacturer code "01": Press "0" then
"1".
When the unit is shipped, the manufacturer code is set to
(01).
4
Press ENTER.
Manufacturer code list
5
Release TV/VIDEO - CANCEL.
6
Try to operate the TV by pressing TV STANDBY/ON
.
If your TV turns on or off, you have successfully set
the control signal.
The following buttons can be used for operating the
TV.
To use
§
/
(CH–, CH+),
Ó
/
Á
(VOL–, VOL+), TV/
VIDEO- CANCEL and numeric buttons for TV control,
set the TV - DVD switch to "TV".
Use the VOL - and VOL + buttons on the remote control
unit to adjust the analog output level. The level is shown
on the display of the unit, where 0 is the default
(maximum) level, and -12 is the minimum level. Pressing
the VOL - button reduces the level, and VOL + increases
the level.
*Even at the minimum level, there is still some signal
- the output is not completely muted.
*The digital output level cannot be adjusted.
To use the remote control unit for TV
operation
Manufacturer
No. Manufacturer No.
AIWA 36 MIVAR 29
BEIJING 22 NEC 20
CCE 02 NOBLEX 22
CHANGHONG 34 NOKIA 31
DAEWOO 17, 37 PANASONIC 04, 11
FERGUSON 27 PEONY 34, 38, 39
FINLUX 30 PHILCO 10, 17, 21
FUNAI 32 PHILIPS 02
GRADIENTE 15, 20 RCA 05
GRUNDIG 19 SAMSUNG 12, 33, 34,
35
HITACHI 10
ITT 28 SANYO 13, 16
JINXING 38 SEARS 13
JVC 01, 23,
24, 25
SHARP 06
SONY 07
KONKA 40 TCL 41
LG (GOLDSTAR) 18 THOMSON 26
MAGNAVOX 02 TOSHIBA 08,14
MITSUBISHI 03 ZENITH 09
TV/VIDEO -
CANCEL
Numeric buttons
TV - DVD switch
ENTER
TV STANDBY/ON
Turns the TV on or off.
Switches the TV input mode between TV
and VIDEO.
Selects the TV channels directly.
*For some TVs, pressing "+10" functions
as the "100+," while "10" functions as the
ENTER button if your TV requires
pressing the ENTER button after
selecting a channel number.
Mutes the TV sound.
Changes the TV channels.
Adjusts the output volume.
NOTE
If there is more than one code listed for the
manufacturer of your TV, try them one by one until you
succeed.
To adjust the analog output level
TV DVD
TV
TV/VIDEO
CANCEL
~
TV1
1
TV-/--
10
TV0
0
MUTING
+10
CH
+
CH
-
VOL
-
VOL+
VOL