Filter
Top Products
English - 16 -
TV Type
Digital terrestrial television channels can broadcast
programmes in a widescreen format which must
be output differently to normal and widescreen TV
sets. This function tells the receiver the screen
format of the TV connected so that broadcasts are
displayed correctly. Highlight the TV Type line in
the Confi guration menu and use the “
”/“ ” keys to
select 4:3 if you have a standard TV set connected
or 16:9 if it is a widescreen TV. If you choose “Auto”,
the TV type will be set automatically according to the
broadcasted programme. This function duplicates the
selection made at the time of fi rst installation and can
be used if you change TV sets.
TV Out
The receiver can output RGB and CVBS signal
from the TV SCART on the rear panel. Although the
RGB format results in a better quality picture, not all
equipment can cope with an RGB signal.
Favourite Mode
This function enables or disables the favourite channel
list mode by pressing “
”/“ ” buttons. If a favourites
list exists it will switch to the list number selected. If
there is no favourite listing, a warning message is
displayed.
Channel List
Use “ ”/“ ” buttons to go to Channel List option.
Use “
”/“ ” buttons to toggle Channel List Mode. If
you select “TV Only” you navigate through only TV
channels, if you select “Radio Only” you navigate
through only radio channels, if you navigate “Text
Only” you navigate through only Text channels with
the PR+/PR- buttons. If you choose “Show All” all,
channels can be navigated with the PR+/PR- buttons.
To save the recent changes and exit; press the MENU
button.
Scan Encrypted
Use“ ”/“ ” buttons to go to the Scan Encrypted
Channels option. Use “
”/“ ” buttons to toggle YES
or NO the searching for encrypted channels.
Auto Power Down
This box will automatically switched from active mode
into standby mode, after less than three hours in
active mode, following the last user interaction and/or
a channel change with an alert message two minutes
before going in to standby mode. The Automatic
power-down will be set as default and the user will
be able to change Automatic power down to on or off
in the menu.
Receiver Upgrade
Over Air Download (OAD): To ensure that your STB
always has the most up todate information. Please
ensure that after use it is set to its standby mode.
The STB automatically powers up at 3.00 A.M. each
day and searches for any new information which may
be broadcast and will download this to your receiver
automatically. This operation will normally take
approximately 30 minutes. If you have an important
recording to make at 3.00 A.M. which must not have
a 30 minutes interrupt then you can disable the auto
OAD search by performing the following:
• Press Menu button and using the “
”/“ ” buttons to
choose Setup and press the OK button.
• Highlight Confi guration menu with “
”/“ ” keys and
pres OK.
• Use “
”/“ ” buttons to choose “RECEIVER
UPGRADE” and press OK button.
• Using the left / right button change “Automatic
scanning” from Enabled to Disabled.
• Highlight “Scan for upgrade” menu with “
”/“ ” keys
and press OK to commence upgrade.
Do not forget to re enable the automatic OAD function
after you have made your recording by repeating the
above instructions but this time selecting ENABLE.
Parental Locking
Use “ ”/“ ” buttons to go to Parental Lock option.
Press OK button to enter the menu. A box asking for
the lock key is displayed. The key is set to “0000”
initially. Enter lock key. If it is incorrect, “Wrong Pin”
is displayed. If it is correct, the Parental Control Menu
is displayed.