Filter
Top Products
English - 13 -
Initial Settings
When the TV is turned on for the fi rst time, the menu
for the language selection appears on the screen. The
message “Welcome please select your language!” is
displayed in all language options sequentially in the
On Screen Display (OSD).
By pressing the “
” or “ ” buttons highlight the
language you want to set and press OK button. After
then, “First time installation” On Screen Display (OSD)
will appear on the screen.
By pressing “ ” or “ ” buttons, select the country
you want to set and press OK button. button (** for
EU countries).
Note: Country selection On Screen Display (OSD) will
not be available for UK.
After then, the active antenna selection On Screen
Display (OSD) appears on the screen:
By pressing “ ” or “ ” buttons, set active antenna
mode as on or off.
If an active antenna is connected to your TV, you
can select this option as On. Antenna power should
be “Off” when standard antenna is used instead of
the active antenna. See Confi guration Menu in the
following sections for more information.
Press OK button on the remote control to continue
and the following message will be displayed on the
screen:
• To select the “Yes” or “No” option, highlight the
item by using “ ” or “ ” buttons and press the OK
button.
The IDTV will automatically tune to the UHF or VHF
(** for EU countries) transmission channels, searching
for digital terrestrial TV broadcasts and displaying the
names of channels found. This process will take about
a few minutes. To cancel searching, you can press the
“M” button at any time during the process.
After Automatic Search is completed, the following
message asking for analogue channel search appears
on the screen:
To search for analogue channels, select “Yes”. TV
switches to the analogue TV mode. The menu below
is displayed to search for analogue channels:
Select your Country, Language and Text language
by using “ ” or “ ” and “ ” or “ ” buttons. Press
OK or RED button to continue. To cancel, press the
BLUE button.
For more information on this process, see “Install
Menu” section.
Note : For proper functioning of digital teletext in DTV
mode, you should set country as UK in analogue
AUTO PROGRAM (for UK only).