Filter
Top Products
English - 12 -
Initial Settings
When the TV set is operated for the fi rst time, the
Digital TV turns on fi rst.
Because this is the fi rst time the TV is used, there are
no channels stored in the memory.
When the TV is turned on for the fi rst time, the menu
for the language selection appears on the screen. The
message “Welcome please select your language!”
is displayed in all language options sequentially in
the OSD.
By pressing the “ ” or “ ” buttons highlight the
language you want to set and press OK button. After
then, “First time installation” OSD will appear on the
screen. By pressing “ ” or “ ” buttons, select the
country you want to set and press OK button (* for
EU countries).
Note: Country selection OSD will not be available
for UK.
After then, the active antenna selection OSD appears
on the screen:
By pressing “ ” or “ ” buttons, set active antenna
mode as on or off.
Note: Country selection OSD will not be available
for UK.
After then, the active antenna selection OSD appears
on the screen:
By pressing
“ ” or “ ” buttons, set active antenna
mode as on or off.
If an active antenna is connected to your TV, you
can select this option as On. Antenna power should
be “Off” when standard antenna is used instead of
the active antenna. See Confi guration Menu in the
following sections for more information.
Press OK button on the remote control to continue
and the following message will be displayed on the
screen:
• To select the “Yes” or “No” option, highlight the
item by using “ ” or “ ” buttons and press the OK
button.
The Digital TV will automatically tune to the UHF or
VHF(*) (* for EU countries) transmission channels,
searching for digital terrestrial TV broadcasts and
displaying the names of channels found. This process
will take about a few minutes.
After Automatic Search is completed, the following
message asking for analogue channel search appears
on the screen:
To search for analogue channels, select “Yes”. TV
switches to the analogue TV mode. Analogue search
menu will be displayed.
Select your Country, Language and Text language
by using “ ” or “ ” and “ ” or “ ” buttons. Press
OK or RED button to continue. To cancel, press the
BLUE button.
For more information on this process, see “Install
Menu” section.
Note : For proper functioning of digital teletext in DTV
mode, you should set country as UK in analogue
AUTO
PROGRAM (for UK broadcasts only).
Do not turn off the TV while initializing
fi rst time
installation.
[GB]_MB25_(01-TV)_COST_1900UK_PEUIDTV_22855W_NICKEL5_10065841.indd 12[GB]_MB25_(01-TV)_COST_1900UK_PEUIDTV_22855W_NICKEL5_10065841.indd 12 02.11.2009 15:00:0902.11.2009 15:00:09