Filter
Top Products
English - 12 -
If an active antenna is connected to your TV, you
can select this option as On. Antenna power should
be “Off” when standard antenna is used instead of
the active antenna. See Confi guration Menu in the
following sections for more information.
Press OK button on the remote control to continue
and the following message will be displayed on the
screen:
• To select the “Yes” or “No” option, highlight the
item by using “ ” or “ ” buttons and press the OK
button.
The IDTV will automatically tune to the UHF or VHF
(** for EU countries) transmission channels, searching
for digital terrestrial TV broadcasts and displaying the
names of channels found. This process will take about
a few minutes. To cancel searching, you can press the
“M” button at any time during the process.
After Automatic Search is completed, the following
message asking for analogue channel search appears
on the screen:
To search for analogue channels, select “Yes”. TV
switches to the analogue TV mode. The menu below
is displayed to search for analogue channels:
Select your Country, Language and Text language
by using “ ” or “ ” and “ ” or “ ” buttons. Press
OK or RED button to continue. To cancel, press the
BLUE button.
For more information on this process, see “Install
Menu” section.
Note : For proper functioning of digital teletext in DTV
mode, you should set country as UK in analogue
AUTO PROGRAM (for UK only).
General Operation
Pressing the “TV/DTV” button at any time while
watching television programmes will switch the TV set
between the digital terrestrial television broadcasting
and its normal analogue broadcasting.
Information Banner
• Whenever you change channel, using the P- / P+
button or the numeric buttons, the TV displays the
broadcast picture along with an information banner
at the bottom of the screen (available only in DTV
mode). This will remain on the screen for a few
seconds.
• The information banner can also be displayed at any
time while watching TV by pressing the INFO button
on the remote control:
Hint: Not all channels broadcast the programme
data. If the name and time of the programme are not
available, then information banner will be displayed
with blanks.
If the selected channel is locked, you must enter the
correct four numeric code to view the channel. “ Enter
PIN ” will be displayed on the screen in such a case:
Electronic Programme Guide
(EPG)
• Some, but not all, channels send information about
the current and next events.
• Please note that event information is updated
automatically. If there is no event information data
available in channels, EPG will be displayed with
blanks.
[GB]_MB35_COST_40882W-1810UK_PANEUIDTV_BRONZE2_10064946_50164710..indd 12[GB]_MB35_COST_40882W-1810UK_PANEUIDTV_BRONZE2_10064946_50164710..indd 12 17.02.2010 14:17:1317.02.2010 14:17:13