Filter
Top Products
07303C DCN6646 11
3.0 GETTING STARTED
The NOy converter has been designed to operate with the T200U low level NOx
analyzer, with some additional modification.The combination is referred to as the
T200U-NOy analyzer.
3.1 Unpacking and Inspection
The T200U- NOy comes in three boxes:
The analyzer with AC power cord
501Y Bypass Pump Chassis (typically referred to as “501Y herein) with AC
power cord
External Converter housed in a stainless steel shelter, and an umbilical cable
assembly (herein referred to as “Converter” or “external Converter”)
External Pump (herein referred to as “external Pump” not to be confused with
the 501Y By
pass Pump)
1. Verify that there is no apparent shipping damage. If damage has
occurred please advise shipper first, then TAPI. (Keep original
container and packaging for shipper’s inspection).
2. Before operating the analyzer, remove the shipping screws as shown in
the T200 Manual.
3. Please check the voltage and frequency label on the rear panel of the
instrument for compatibility with the local power before connecting
the instruments to a power source.
CAUTION!
Avoid personal injury: use two persons each to lift and carry the analyzer and the
Model 501 Pump Pack chassis.