Filter
Top Products
10
SP :
standard play.
LP :
long play.
Programming the remote control unit to control a video recorder.
1 - Press the VCR key.
2 - Hold the MENU key down and type one of the 3-digit codes corresponding to the brand of your VCR (see
table on the following page).
3 - Release the MENU key.
4 - Try to put your video recorder into stand-by with the
BB
key on the remote control unit.
If it does not go to stand-by, try another code.
Depending on the year your video recorder was made and
on the equipment, some functions may not be available.
Some codes may cover more functions than others.
Try out the functions that you can control and perhaps try
other codes.
Note here the code that suits
best.
When you change the batteries in the remote control unit,
you must re-program it.
Video recorder keys
0000 :
reset/erase.
MARK :
mark.
STOP :
stop.
REC. + PLAY :
record.
PLAY :
play.
F.FWD :
fast forward.
REW. :
fast rewind.
PAUSE. :
pause.
To control your VCR
(model 2100 only)
tx807en1 4/02/00 11:05 Page 10