Filter
Top Products
66
Manual Channel Set-up
With the manual set-up
1. Display the menu by pressing a number of times
on the remote control menu key:
- twice for the mono TV sets.
- 3 times for the stereo TV sets.
The first line (Standard) is selected.
Depending on the model of your TV set, you'll have
to select from the options listed below the one that
fits with your country:
EURO : Western Europe, Tunisia, Morocco
FR : France, Luxembourg
UK : United Kingdom, Eire
DK : Eastern Europe, Middle East, Africa,
French DOM-TOM
Select corresponding option by means of the
directional keys Left/Right.
2. Select the Mode line through the Up/Down
directional keys.
3. By means of the Left/Right directional keys, select
ANTENNA (reception through an aerial antenna) or
CABLE (reception through a cable network) for a
Channel set-up, or MHz for a Frequency set-up.
4. Select the CH or CC line through the Up/Down
directional keys.
5. Start the set-up in a decreasing or increasing order
by means of the Left/Right directional keys.
When a channel is found, the pictures appear. If the
picture quality is poor, make use of the directional
keys Up/Down to select the line ->.<- and try to
improve picture quality with the directional keys
Left/Right.
6. Select the Decod. line through the Up/Down
directional keys.
7. By means of the Left/Right directional keys, select
ON (if the channel is scrambled and a decoder
connected to the AV connection) or OFF if such is
not the case.
8. Then select the Pr line through the Up/Down
directional keys and enter the channel number
corresponding to the pictures. You may also use the
Left/Right keys.
9. Select the Text line through the Up/Down keys
and choose the character set table to be used for
videotext:
1: Western Europe
2: Eastern Europe
3: Greek, Turkish
4: Arab
10. Store the programme by pressing OK.
To find the next programme, re-start Channel Set-up
by means of the directional keys Left/Right.
Once the set-up achieved, close the menu through
exit.
Adjusting the Picture
Press the menu key once to display the menu.
Through the Up/Down keys, select the function you
want to adjust (Brightness, Colour, Contrast,
Sharpness, Tint).
Adjust with the Left/Right keys.
The tint adjustment is only possible for a NTSC
picture.
If you want to preserve these adjusments as preferred
settings, press the red key during 3 seconds to store
them.
You’ll then be able to recall them later on.
Close the menu through exit.
Settings are stored until you proceed to another
change.
Adjusting the Sound
(only on stereo models)
Press the menu key twice to display the menu.
Through the Up/Down keys, select the function you
want to adjust (Treble, Bass, Balance, Mode).
With the Left/Right keys, adjust the Treble or Bass
level, the balance between left and right paths and the
type of sound you want (Mono or Auto).
If Auto has been selected, the TV set will
automatically adjust to the sound transmitted by the
channel.
If you want to preserve these adjustments as
preferred settings, press the red key during 3 seconds
to store them.
You’ll then be able to recall them later on.
Close the menu through exit.
Settings are stored until you proceed to another
change.
tx807en1 4/02/00 11:05 Page 6