Filter
Top Products
10
11. To confirm that the component key is programmed with the
correct code for maximum functionality, test the component.
Attempt to control a variety of the component’s functions
with the remote. If some of the features of your components
do not work, try programming the remote with a different
code in the list until you find the code that allows the remote
to control the majority of your component’s functions.
Different codes can provide different levels of functionality.
12. Remember to enter the codes for future reference
in the boxes provided with Code Retrieval section
on pages 10 and 11.
Programming Methods (continued)
9. When your component turns off, you
know the correct code is in the last
block of 10 codes sent. Press and
release the REVERSE key. Wait two
seconds to see if your component turns
on again. If your component does not
respond, continue to press the
REVERSE key every two seconds until
your component turns on again. This
will isolate the correct code in the last
block of codes sent. Each time the
REVERSE key is pressed, the
illuminated ON•OFF key blinks.
Note: If you accidentally press the
REVERSE key after your component
responds, press and release the
FORWARD key. Then, wait two
seconds to see if your component
turns off again.
10. Once your component turns on, you
have found the correct code. You
must save the new code by pressing
and releasing the STOP key. The
illuminated ON•OFF key turns off.
You must press the STOP key
to save the code or the correct code
will not be stored!
ON•OFF
STOP
FORWARD
REVERSE
ON•OFF
(BLINK)
Once you’ve programmed the remote to control your
components, you may want to record the codes for future
reference. If you used the Direct Code Entry method, this is
easy. Just find the codes you programmed in and make a note
of them in the boxes below. If you used one of the Code
Search methods to program your remote, you will need to
retrieve each component’s four-digit code. Retrieving the
actual code and writing it down will save you time if you ever
need to program the remote again (e.g., if programming is lost
when you change the batteries). If the codes are recorded, you
can use the Direct Entry method to reprogram your remote to
control your components, which is quick and easy.
Code Retrieval
ON•OFF
SAT
•CBL
VCR•DVD
TV
ON•OFF
INFO
1. Press and hold the component key
(TV, VCR•DVD, SAT•CBL) whose
code you wish to retrieve. The
illuminated ON•OFF key turns on.
2. While holding the component key
down, press and hold the INFO key.
The illuminated ON•OFF key turns off.
3. After holding down both keys for
three seconds, the illuminated
ON•OFF key turns back on.