Filter
Top Products
6
Direct Code Entry
To program your universal remote to control your components
using the Direct Code Entry Method, follow the steps below.
brand lists have been searched and
another programming method should
be tried. The Brand Code Search
mode is exited.)
11. Once you have found the correct
code, you must save that code by
pressing and releasing the STOP key.
The illuminated ON•OFF key turns
off. You must press the STOP key to
save the code or the correct code will
not be stored!
12. To confirm that the component key
is programmed with the correct code
for maximum functionality, test the
component. Attempt to control a
variety of the component’s functions
with the remote. If some of the
features of your component do not
work, try programming the remote
with a different code in the list
until you find the code that allows
the remote to control the majority
of your component’s functions.
Different codes can provide different
levels of functionality.
3. Press and hold the component key
(TV, VCR•DVD, SAT•CBL) you wish
to program. The illuminated ON•OFF
key turns on and remains on. If you
release the component key at any
time during the Direct Code Entry
procedure, the illuminated ON•OFF
key blinks four times, and the process
is exited.
4. While holding down the component
key, consult the Code Lists for the
four-digit code that corresponds to
your component’s brand and use the
number keys (0-9) on the keypad to
enter it. While you are pressing the
numbers, the illuminated ON•OFF
key turns off.
5. After the fourth number is entered,
the illuminated ON•OFF key turns
on. At this time, release the component
key. If the illuminated ON•OFF key
turns off, you have entered a valid
code and have followed the correct
procedure for Direct Code Entry.
If you enter a code number that is not
in the Code Lists or you do not
follow all of the steps for Direct Code
Entry, the illuminated ON•OFF key
blinks four times when the
component key is released. This is an
Programming Methods (continued)
STOP
ON•
OFF
ON•OFF
ON•OFF
(BLINK)
ON•OFF
(BLINK)
SAT
•CBL
VCR•DVD
TV
13. Remember to enter the code for future reference in the box
provided in the Code Retrieval section of this manual (see
pages 10 and 11).
If none of the codes work, use one of the other programming
methods to program your remote.
1. Manually turn on the component you want the remote to
control (TV, VCR, DVD, satellite receiver or cable box).
2. Locate the enclosed Code Lists. Find the list for the
component you wish to program. Find your component’s
brand. You will see a listing of four-digit codes for each
brand. If your brand isn’t listed, use one of the Code Search
methods to program the remote control. (Refer to pages 7
and 8 for Manual and Auto Code Search methods.)