Filter
Top Products
TIP: Throughout the programming of each key, be sure to
keep the remote pointed at the IR sensor of the component you
are currently programming the remote to control.
6. To confirm that the component key is programmed with
the correct code for maximum functionality, test the
component. Attempt to control a variety of the component’s
functions with the remote. If some of the features of your
components do not work, try programming the remote
with a different code in the list until you find the code that
allows the remote to control the majority of your
component’s functions. Different codes can provide
different levels of functionality.
7. Remember to enter the code for future reference in the box
provided in the Code Retrieval section of this manual
(see pages 10 and 11).
7
indication that a programming error
has occurred. In that case, repeat the
Direct Code Entry process from step 3
and try the next code listed.
Manual Code Search and Entry
If your component’s brand isn’t listed in the Code Lists, or if
you have tried all of the codes for your brand and the remote
does not operate your component, try one of the Code Search
methods below—Manual Code Search or Auto Code Search.
Both Code Search methods cycle through all of the codes in the
Code Lists in the event that your component’s code is listed
under another brand.
The Manual and Auto Code Search methods may take a long
time because the remote searches through all of the codes in its
memory for the code that operates your component. Therefore,
if your brand is listed in the Brand Codes or the Code Lists, first
try the Brand Code Search or the Direct Code Entry methods
described on pages 4 and 6.
TIP: To exit without saving at any
point in the Manual Code Search, press
and release the GO BACK key.
GO BACK
1. Manually turn on the component you want the remote to
control (TV, VCR, DVD, satellite receiver or cable box).
Note: If you press an invalid key during the Manual Code
Search, the remote does not respond and the illuminated
ON•OFF key does not blink. If you do not press a valid
Manual Code Search key (TV, VCR•DVD, SAT•CBL,
ON•OFF, GO BACK), the search times out after two minutes.
When the search times out, the illuminated ON•OFF key
blinks four times and turns off. The last programmed code
under that component key is retained.
2. If you are programming your TV or satellite receiver, go
directly to step 4.
3. To program the remote to control a VCR or DVD. The
VCR•DVD key can control only one component, either your
VCR or your DVD. To program your remote to control either
your DVD or your VCR, you must first put the remote in the
proper programming mode. Follow these directions before
proceeding to step 4.
a. Press and hold the VCR•DVD
key. The illuminated ON•OFF
key turns on.
b. While holding down the
VCR•DVD key, press and release
the number 2 key on the keypad
to control a VCR or the number
3 key to control a DVD. The
illuminated ON•OFF key blinks,
and then turns back on.
c. Release the VCR•DVD key. The
illuminated ON•OFF key blinks
four times and then turns off.
Your remote is now either in
VCR or DVD Programming
Mode, depending on which you
chose. Proceed to step 4.
VCR•DVD
VCR•DVD
VCR•DVD
ON•OFF
(BLINK)
ON•OFF
(BLINK)