Filter
Top Products
Controls and displays
05
27
En
English
Français
Deutsch
Nederlands
Italiano
Español
AUTO SURR
– Selects Auto Surround
(
Auto playback
on page 28).
DIALOG E
– Use to make dialog stand out
when watching TV or a movie (page 32).
S. RETRIEVER
–
Press to restore CD quality
sound to compressed audio sources (page 32).
ACOUSTIC EQ
– Press to select an
Acoustic Calibration EQ setting (page 30).
SIGNAL SEL
– Use to select an input signal
(page 33).
9
SHIFT
Press to access the DVR controls (above the
component control buttons) as well as some
receiver controls.
10 INPUT SELECT
Use to select the input source (use
SHIFT
for
INPUT SELECT
).
11
SOURCE
Press to turn on/off other components
connected to the receiver.
12 Character display (LCD)
This display shows information when
transmitting control signals.
The following commands are shown when
you’re setting the remote to control other
components (see
Controlling the rest of your
system
on page 48):
SETUP
– Indicates the setup mode, from
which you choose the options below.
PRESET
– See
Selecting preset codes
directly
on page 49.
DIRECT F
– See
Direct function
on page 49.
RESET
– See
Erasing all of the remote
control presets
on page 49.
READ ID
– See
Confirming preset codes
on
page 50.
13 RECEIVER
Switches the remote to control the receiver
(used to select the green commands above the
number buttons (
DIMMER
, etc). Also use this
button to set up surround sound (page 9,
page 36).
14 VOL +/–
Use to set the listening volume.
15 MUTE
Mutes the sound or restores the sound if it has
been muted (adjusting the volume also
restores the sound).
16 EFFECT/CH SEL
Press repeatedly to select a channel, then use
+/–
to adjust the level
(see
Tip
on page 44). Also
adjusts the level of the Advanced Surround
effects, Dolby Pro Logic IIx Music, and Neo:6
Music parameters (page 29). You can then use
the
+/–
buttons to make these adjustments.
Operating range of remote control
The remote control may not work properly if:
• There are obstacles between the remote
control and the receiver's remote sensor.
• Direct sunlight or fluorescent light is
shining onto the remote sensor.
• The receiver is located near a device that is
emitting infrared rays.
• The receiver is operated simultaneously
with another infrared remote control unit.
D
O
W
N
30
30
7 m
D
O
W
N
VSX_816.book.fm 27 ページ ２００６年２月２０日 月曜日 午後２時１４分