Filter
Top Products
USB playback07
34
En
Chapter 7:
USB playback
Using the USB interface
It is possible to listen to two-channel audio
1
using the USB interface on the front of this
receiver. Connect a USB mass storage device
2
as shown below.
1 Press USB (
SHIFT
+AM).
2 Connect your USB device.
The USB terminal is located on the front panel.
3 Press
(play) to start playback.
Files/folders play in sequential order based on
the filename (according to the Unicode
standard). Within a given directory, all files are
played before continuing to folders/subfolders.
In the diagram below, playback proceeds from
folder 0 to folder 5, playing files 1 to 8 in order.
• Make sure the receiver is in standby when
disconnecting the USB device.
Basic playback controls
The following table shows the basic controls on
the remote for USB playback.
Important
If a
USB ERR
message lights in the display, try
following the points below:
• Switch the receiver off, then on again.
• Reconnect the USB device with the
receiver switched off.
Note
1 This includes playback of WMA/MP3/MPEG-4 AAC files (except files with copy-protection or restricted playback).
2• Compatible USB devices include external magnetic hard drives, portable flash memory (particularly keydrives) and digital
audio players (MP3 players) of format FAT16/32. It is not possible to connect this unit to a personal computer for USB playback.
• Pioneer cannot guarantee compatibility (operation and/or bus power) with all USB mass storage devices and assumes no
responsibility for any loss of data that may occur when connected to this receiver.
• With large amounts of data, it may take longer for the receiver to read the contents of a USB device.
Folder 0
(Root)
Folder 1
(Artist)
file 1
file 2
file 3
Folder 2
(Album)
Folder 5
(Artist)
Folder 4
(Album)
Folder 3
file 5
file 6
file 4
file 8 file 7
Button
What it does
Starts normal playback.
Pauses/unpauses playback.
Press to start fast reverse scanning
(press twice for high-speed scanning).
Press to start fast forward scanning.
(press twice for high-speed scanning).
Skips to the start of the current track,
then previous tracks.
Skips to the next track.
USB ERR
What it means
USB ERR1
The power requirements of the USB
device are too high for this receiver.
USB ERR2
The USB device is incompatible
USB ERR3
See
Troubleshooting
on page 61 for
more on this error message.
VSX_816.book.fm 34 ページ ２００６年２月２０日 月曜日 午後２時１４分