Filter
Top Products
Listening to your system
06
33
En
English
Français
Deutsch
Nederlands
Italiano
Español
Playing other sources
1 Turn on the power of the playback
component.
2 Turn on the power of the receiver.
3 Select the source you want to playback.
Use the input select buttons.
1
4 Start playback of the component you
selected in step 1.
Choosing the input signal
• Default setting:
AUTO
You need to hook up a component to both
analog and digital inputs on the rear of the
receiver to select between input signals.
2
• Press
SIGNAL SEL (SIGNAL SELECT
) to
select the input signal corresponding to the
source component.
Each press cycles through the options as
follows:
•
AUTO
– This is the default setting. The
receiver selects the first available signal in
the following order:
DIGITAL
;
ANALOG
.
•
ANALOG
– Selects an analog signal.
•
DIGITAL
– Selects an optical or coaxial
digital signal.
When set to
DIGITAL
or
AUTO
,
2
DIGITAL
lights when a Dolby Digital signal is input, and
DTS
lights when a DTS signal is input.
Selecting the multichannel
analog inputs
If you have connected a decoder or a DVD
player with multichannel analog outputs to this
receiver (page 14), you must select the analog
multichannel inputs for surround sound.
3
1 Make sure you have set the playback
source to the proper output setting.
For example, you might need to set your DVD
player to output multichannel analog audio.
2 Press
DVD
.
3 Press
SIGNAL SEL (SIGNAL SELECT
) to
select the multichannel analog inputs.
DVD 5.1ch
shows in the display and the
ANALOG
indicator lights.
Note
1 If your source is the TV’s built-in tuner, switch to the channel you want to watch, otherwise make sure that the TV’s video input
is set to this receiver (For example, if you connected this receiver to the
VIDEO
jacks on your TV, make sure that the
VIDEO
input
is selected). Turn down the volume of your TV so that all the sound is coming from the speakers connected to this receiver.
2• This receiver can only play back Dolby Digital, PCM (32 kHz to 96 kHz), DTS and WMA9 Pro digital signal formats. With other
digital signal formats, set to
ANALOG
.
• You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make
the proper digital connections (
Connecting other audio components
on page 15) and set the signal input to
DIGITAL
.
• Some DVD players don’t output DTS signals. For more details, refer to the instruction manual supplied with your DVD player.
3• During playback from the multichannel inputs, you can’t use any of the sound features/modes and only the volume and
channel levels can be set.
• You can’t listen to your speaker B (Second Zone) system during playback from the multichannel inputs.
VSX_816.book.fm 33 ページ ２００６年２月２０日 月曜日 午後２時１４分