Filter
Top Products
TROUBLESHOOTING(Q & A)
TROUBLESHOOTING (Q & A)
Problem Possible Causes What to do
Nothing appears on the
Front Panel.
No sound or picture, but
the front panel shows the
time or -- : --
No Picture, No Sound.
The Remote Control Unit
(RCU) is not working.
Time Setting is wrong.
2 broadcasts overlap.
The main power cable
is not connected.
STB is in standby mode.
The satellite dish is not
pointing at the satellite.
No Signal or Weak Signal.
LNB is faulty.
The UHF Key is
pushed down .
No Batteries.
The RCU is incorrectly
aimed.
The STB is in standby
mode.
The Time is not set properly.
The channels are not
configured properly on the
RF mode.
Check that the main power
cable is plugged into the power
socket.
Turn the power ON.
Adjust the dish.
Check the settings in one of
the channel search submenus.
Check the cable connections.
Replace the LNB.
Get out of the UHF mode.
Change the batteries (both).
Aim the RCU properly to
the STB.
Change the mode to the
normal mode.
Adjust the Time on the Menu.
You have forgotten your
secret PIN Code.
Contact your Service Provider.
Set the channels in the RF mode
under the A/V setting of the
Menu between 21 to 69 on the TV.