Filter
Top Products
POSITIONERSETTINGGUIDE
3) The Most Eastern Satellite
. Repeat the first 2 steps(Satellite Name, Frequency) as listed above.
. Position dish : Press the button to search and allocate the antenna to the adequate
position. The positioning procedure might not succeed the first time. (Repeat the
procedure, if it is needed.) As you press the / button, the cursor will subsequently
move to the left/right until it finds the matching position. As soon as the cursor finds the
position, the signal quality (yellow bar) will appear.
. Align dish : In the position, peak the dish to obtain the highest signal quality using
the or buttons.
Press the red (F1) button to save it!
4) Program Satellites
Now go to the Satellite Name section and press to display the satellite list.
Accordingly, check all satellites you want to positioned between the most western
and the most eastern satellite using the button. Press the red (F1) button to save it.
Let the receiver calculate all intermediate satellite positions. All selected satellite
positions are now stored.
The STB now has programmed the position of all selected satellites. Next step is to
store all channels on the satellite. Under the same Dish Setting menu, go to the
Channel Search section. Select the Start Search...section to launch the searching
procedure and to store all channels.
Repeat this procedure for all satellites.
D. Manual Setting
Positioner Setting Guide Positioner model only
1) Satellite Name : Press the button to
display the satellite list. Choose the desirable
most western satellite among the list by
highlighting it and pressing the button.