Toshiba 32 80cm CRT Television User Manual


 
1/2
SET UP
Language English
Country UK
Auto tuning
OK
Manual tuning
OK
Antenna Amplifier On
AV connection
OK
MENU
Back
EXIT
Watch TV
Input selection and
AV connections
33
Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 7
for a clear view of the back connection recommendations.
Most media recorders and decoders send a signal
through the SCART lead to switch the television to the
correct Input socket.
Alternatively press the external source selection button
B
until the picture from connected equipment is shown.
This button must be used to view equipment connected
using the COMPONENT VIDEO INPUT (EXT3C).
An S in the display e.g.
B
2S (EXT 2S), indicates the
input is set for an S-Video signal.
Input selection
1
This specifies the type of signal going into SCART 2 (EXT2)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
In the SET UP menu press
e
until
AV connection is highlighted, then press OK.
With
z
or
x
select either AV or S-VIDEO as the
required input for EXT2.
If the colour is missing try the alternative setting.
INPUT signal selection
1
2
At any time by pressing
B
a list will appear on
screen showing modes and all stored external
equipment. Use
e
and
f
to highlight and OK to
select.
AV connection
PC/HDMI1 audio PC
HDMI1 audio Digital
EXT1 output DTV
EXT2 input AV
EXT2 output DTV
Woofer Internal
MENU
Back
EXIT
Watch TV
ATV
PC
HDMI2
HDMI1
B
3C
B
2
B
1
DTV
NOTE: When in digital mode ATV cannot be
selected, in analogue mode DTV cannot be
selected. To switch between DTV and ATV press
the A/D button.
HDMI™ displays equipment connected to Input
HDMI on the back of the television. It is designed
for best performance with 1080i high definition
signals.
PC displays a computer connected to Input
RGB/PC on the back of the television.
ATV
PC
HDMI2
HDMI1
B
3C
B
2
B
1
DTV
C3000D Eng OM 28/1/07 6:01 pm Page 33