Toshiba 32 80cm CRT Television User Manual


 
AV connection
PC/HDMI1 audio PC
HDMI1 audio Digital
EXT1 output DTV
EXT2 input AV
EXT2 output DTV
Woofer Internal
MENU
Back
EXIT
Watch TV
AV connection
PC/HDMI1 audio HDMI1
HDMI1 audio Auto.
EXT1 output DTV
EXT2 input AV
EXT2 output DTV
Woofer Internal
MENU
Back
EXIT
Watch TV
1/2
SET UP
Language English
Country UK
Auto tuning
OK
Manual tuning
OK
Antenna Amplifier On
AV connection
OK
MENU
Back
EXIT
Watch TV
34
Input selection and
AV connections
continued
In the SET UP menu press
e
until
AV connection is highlighted, then press OK.
1
2
HDMI, the HDMI logo, and High-Definition Multimedia
Interface are trademarks or registered trademarks of HDMI
Licensing, LLC.
HDMI1 audio
If the connected HDMI source does not support digital
audio, plug the audio cable into PC/HDMI1 audio on the
back of the television (as shown in the ‘Connecting a
computer’ section), then use the HDMI1 audio settings.
In the AV connection menu press
e
to highlight
PC/HDMI1 audio and using
x
select HDMI1.
Then highlight HDMI1 audio and using
z
or
x
select Auto., Digital or Analogue.
If the sound is missing select an alternative
setting.
NOTE: HDMI1 supports digital and analogue
sound, HDMI2 is digital sound only.
Certain formats of DVD disk may not output from
this TV (32/44.1/48kHz and 16/20/24 bits are
acceptable).
2
Highlight PC/HDMI1 audio then use to
x
select
the PC option.
NOTE: Selecting the PC option will force HDMI
into digital audio.
In order to receive sound from a connected PC, plug the
audio cable into the back of the television (as shown in
Connecting a computer’ section), then use the
PC/HDMI1 audio settings.
PC audio
1
This is a digital television which is integrated to allow the
use of both digital and analogue services. However,
during the lifetime of this set it is very likely that
analogue services will be switched off to allow for more
new digital services.
This ‘switch-off’ will happen in a number of phases,
which will be advertised in your area well in advance.
It is recommended that at each phase the television is
re-tuned to ensure that existing and new digital
services can be viewed without disruption
(see the 'Auto tuning' section).
Analogue switch-off
*
C3000D Eng OM 28/1/07 6:01 pm Page 34