Filter
Top Products
12
Using the
Remote Control
Using the remote control
Preparing the remote control for use
The remote control will operate your TV, most VCR models, and
most cable TV converters, even if they are different brands.
• The remote control is preprogrammed to operate most Toshiba
VCRs and cable TV converters.
• If you own a non-Toshiba device or a Toshiba device that the
remote control is not programmed to operate, you will need to
program the remote control. See “Programming the remote
control” on page 13.
Installing the remote control batteries
To install the batteries:
1. Slide the battery cover off the back of the remote control.
2. Install two “AA” size batteries. Match the + and – symbols on
the batteries to the symbols on the battery compartment.
3. Slide the battery cover back onto the remote control until the
lock snaps.
Using the remote control to operate a VCR
or cable TV converter
To control a VCR:
Set the TV/CABLE/VCR switch to the VCR position. The
shaded buttons in the illustration at right will then control the
VCR. The unshaded buttons will operate the TV as usual.
To control a cable TV converter:
Set the TV/CABLE/VCR switch to the CABLE position. The
shaded buttons in the top portion of the illustration at right will
then control the cable TV converter.
Note:
The remote control provided with your TV
may or may not operate certain features on
your VCR, cable TV converter, or other
electronic equipment. Refer to the owner’s
manual provided with your other equipment
to see which features are available. In
addition, the other remote control may have
buttons not available on your TV’s remote
control. If you would like to use those features
or buttons, you may need to use the original
remote control provided with your other
equipment.
Caution:
• Dispose of batteries in a designated
disposal area. Do not throw batteries
into a fire.
• Do not mix battery types or combine used
batteries with new ones.
• Remove dead batteries immediately to
prevent battery acid from leaking into the
battery compartment.
• If you do not intend to use the remote
control for a long time, remove the
batteries.
CHANNEL
NUMBERS
ENT (Used for the
“Enter” command with
some VCRs and cable
TV converters
CHANNEL
y z
TV/CABLE/VCR
switch
VCR buttons (set
TV/CABLE/VCR
switch to “VCR”)
TV
CABLE
VCR
MENU/
ENTER
CH RTN
RECALL MUTE
CH
CH
VOL VOL
1
4
7
2
5
8
3
6
9
0
ENT
100
POWER
o
REWPAUSE
FF
SOURCESTILL
PIP
SLOW
PIP CH LOCATE SWAP
STOP
PLAY
REC
TV/VCR
TV/VIDEOFAV CH
A
EXIT
CT-90037