Filter
Top Products
17
Welcome to
Toshiba
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
TV Front Panel
MENU
yz x •
TV/VIDEO
CHANNEL
yz
CHANNEL
NUMBERS
TV
CABLE
VCR
MENU/
ENTER
CH RTN
RECALL MUTE
CH
CH
VOL VOL
1
4
7
2
5
8
3
6
9
0
ENT
100
POWER
o
REWPAUSE
FF
SOURCESTILL
PIP
SLOW
PIP CH LOCATE SWAP
STOP
PLAY
REC
TV/VCR
TV/VIDEOFAV CH
A
EXIT
CT-90037
RECALL
Selecting the signal source
Use the TV/VIDEO button on the remote control or TV to select the
signal source connected to your TV.
To change the signal source:
Using the remote control: Press TV/VIDEO on the remote
control, and then press the corresponding CHANNEL NUMBER
for the desired source (see the illustration below).
Using the remote control or TV: Repeatedly press TV/VIDEO
until the selected signal source displays in purple.
0: TV
1: VIDEO 1
2: VIDEO 2
3: VIDEO 3
4: ColorStream
To verify the signal source:
Press RECALL or press TV/VIDEO on the remote control once.
Programming channels into the TV’s memory
When you press CHANNEL ▲▼ on the TV or remote control,
the TV stops only on the channels stored in the TV’s memory.
Note: To tune the TV to a channel not programmed into the memory,
use the CHANNEL NUMBERS on the remote control.
Follow the steps below and on the next page to program channels into
the TV’s memory.
Programming channels automatically
Your TV can automatically detect all active channels in your area
and store them in the TV’s memory. After the channels are stored
automatically, you can manually add or erase individual channels
(see page 18).
To program channels automatically:
1. Press MENU.
2. Press
x or • to highlight the SET UP menu.
3. Press
y or z to highlight TV/CABLE.
4. Press
x or • to highlight TV (if you use an antenna) or CABLE (if
you use cable).
5. Press
z to highlight CH PROGRAM.
MOVE SELECT
[
]
[
]
LANGUAGE:
TV/CABLE:
CH PROGRAM
ADD/ERASE:
MORE
[ENGLISH]
FRANCAIS ESPANOL
[TV] CABLE
[ADD] ERASE
SET UP
MOVE SELECT
[
]
[
]
LANGUAGE:
TV/CABLE:
CH PROGRAM
ADD/ERASE:
MORE
[ENGLISH]
FRANCAIS ESPANOL
[TV] CABLE
[ADD] ERASE
SET UP
6. Press x or • to start automatic channel programming (“CH
PROGRAM” displays on-screen). The TV automatically cycles
through every TV or cable channel (depending on which you
selected), and stores all active channels in the TV’s memory.
7. When automatic channel programming is complete, the message
“CH Programming Completed” appears.
8. Press CHANNEL
▲▼ to view the programmed channels.