Toshiba 32dt2u Flat Panel Television User Manual


 
Chapter 6: Using the TV’s features
48
Note: When you turn on the Audio Receiver,
change its input source, or adjust the sound
volume, the sound will be output from the audio
receiver’s speakers even if TV Speakers has
been selected. Turn the TV off and on again to
output the sound from the TV speakers.
To set the REGZA-LINK
®
Setup:
1無
From the Setup menu, highlight REGZA-LINK
Setup and press
.
2無
Press p or q to highlight Enable REGZA-LINK.
3無
Press t or u to select On.
Note: If you select Enable REGZA-LINK Off, the
other items will be grayed out.
4無
Press p or q to highlight the REGZA-LINK Setup
item you want to use, and press t or u to select
On or desired mode.
•
TV Auto Input Switch: On/Off
•
TV Auto Power: On/Off
•
Device Auto Standby: On/Off
•
Speaker Preference: TV Speakers/Audio Receiver
5無
To save the new settings, highlight Done and press
. To revert to the factory defaults, highlight
Reset and press
.
Displaying TV status information
To display TV status information using
RECALL
:
Press
RECALL
on the remote control.
The following information will display (if applicable):
•
Current input (ANT/CABLE, VIDEO, etc.)
•
If ANT/CABLE is the current input, either “CABLE”
(for cable TV) or “ANT” (for over-the-air broadcasts).
•
Channel number (if in ANT/CABLE mode)
•
Digital signal strength indicator (bar graph in lower
right corner of box; for ATSC signal only)
•
Stereo, Mono or SAP audio status (when HDMI input
mode, Dolby Digital or PCM)
•
Video resolution
•
Aspect ratio of incoming video signal (4:3 or 16:9)
•
V-Chip rating status
•
GameTimer (if set)
To close the screen:
Press again.
To display TV status information using INFO:
Press on the remote control.
The following additional information will display for
off air digital channels (if applicable):
•
Title
•
Duration
•
Detailed description
Note:
The location of the banner can be moved
to the top or bottom of the screen by pressing p
or q while the RECALL or INFO display is on-
screen.
Understanding the last mode
memory feature
If power is lost while you are viewing the TV, the
Last Mode Memory feature automatically turns
on the TV when power is restored.
Note: If you will be away from the TV for an
extended period of time you should unplug the
power cord.