Filter
Top Products
…and with the remote control:
Press the Standby Button i:
This allows you to put the set
into standby mode when leaving
the TV unattended for short
periods of time.
To return to TV mode press the
i
button, or any of the
numbered buttons on the remote control. The picture may take a few
seconds to appear.
K
MAIN 8
PB/CB
PR/CR
Y
(AUDIO/VIDEO)
COMPONENT
VIDEO INPUT
(AUDIO/VIDEO)
AUDIO
AUDIO
(4)
EXT INT
K
(AUDIO/VIDEO)
OPTICAL COAXIAL
K
MAIN 8
PB/CB
PR/CR
Y
(AUDIO/VIDEO)
COMPONENT
VIDEO INPUT
(AUDIO/VIDEO)
AUDIO
AUDIO
(4)
EXT INT
K
(AUDIO/VIDEO)
OPTICAL COAXIAL
IN
OUT
IN
OUT
SETTING UP
6
Connecting and turning on your new TV
The TV back connections…
To conserve energy it is best to turn your TV off and not to leave it in Standby, unless the timer has
been set.
Connect the aerial to the socket on the rear of the television. If you use a Set Top Box and/or a video recorder it is
essential that the aerial cable is connected through the Set Top Box and/or through the video recorder to the television.
DO NOT CONNECT SCART LEADS UNTIL THE TELEVISION IS FULLY TUNED.
the back of your TV
AERIAL
VIDEO RECORDER
SET TOP BOX*
AERIAL CABLE AERIAL CABLE
…and switching your new TV on…
ORANGE = Bilingual transmission
being received
GREEN = Stereo transmission
being received
RED = Power On
GREEN = On Timer is set
On the front of the TV…
If the red power-on light is unlit, press the POWER button on the front
of the TV to switch the set on and then press a number button on the
remote control to see the screen.
*
a SET TOP BOX could be:
Digital Satellite, Analogue
Satellite, or any other
compatible decoder.
☛