Filter
Top Products
Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
15
Learning about the remote control
POWER turns the TV on and off (pages 12, 36)
TV/VIDEO selects the video input source (page 34)
CH y and z cycle through programmed channels (page 19)
TV/CABLE/VCR switches between TV, Cable, and VCR (pages 11, 12)
Channel Numbers allow direct access to channels (page 19)
VOL y and z adjust the volume level
CH RTN returns to the last viewed channel (page 21)
ENT required by some VCRs and Cable TV converters to change the
channel
MENU accesses programming menus (page 16)
ENTER sets programmed menu information (page 16)
yz x • selects or adjusts programming menus (page 16)
FAV CH z and y cycle through the channels that are programmed as
favorite channels (page 21)
EXIT exits programming menus (page 16)
PIP Buttons access PIP functions (pages 24–25)
PIP turns the PIP on and off
SOURCE selects the PIP input source
STILL freezes the PIP
SWAP switches the main and PIP pictures
LOCATE changes the position of the PIP window
PIP CH z and y cycle through the PIP channels
VCR Buttons access VCR functions (in VCR mode only; see page 11)
PLAY plays a videotape
STOP stops a videotape
TV/VCR toggles between TV and VCR when viewing
while recording
REC starts recording a videotape
FF fast-forwards a videotape
REW rewinds a videotape
PAUSE freezes a videotape during playback or recording
SLOW plays a videotape in slow motion
MUTE turns off the sound (page 37)
RECALL displays on-screen information (page 42)
TV
CABLE
VCR
12
3
45
6
7
8
9
100
0
ENT
POWER
MUTE
CH RTN
RECALL
CH
VOL
MENU/
ENTER
VOL
CH
FAV CH
TV/VIDEO
STOP
TV/VCR
PLAY
SOURCE
STILL PIP
REC
REW
PAUSESLOW
PIP CH
LOCATE
FF
SWAP
E
I
T
X
The shaded buttons in the illustration below
glow in the dark.