Filter
Top Products
10
Operating with the remote control
* Do not expose the remote sensor of the Blu-ray Disc™
player to a strong light source such as direct sunlight
or other illumination. If you do so, you may not be able
to operate the Blu-ray Disc™ player via the remote
control.
Notes:
• Direct the remote control at the remote sensor of the
Blu-ray Disc™ player.
• When using the remote control, press the buttons at
intervals of about 1 second to ensure the correct mode
of operation.
• Do not drop or give the remote control a shock.
• Do not leave the remote control near an extremely hot
or humid place.
• Do not spill water or put anything wet on the remote
control.
• Do not open the remote control.
• If the remote control is not going to be used for a long
time, remove the battery to avoid damage caused by
battery leakage corrosion.
Identifi cation of Controls
Connections
Connecting to a TV using an HDMI
®
cable
HDMI IN
HDMI Cable
(not included)
HDMI OUT
High
Definition
TV
This connection provides better picture quality and supports up to 1080i/1080p, 1080p/24F resolution.
Connect a HDMI cable from the HDMI output jack on this product to the HDMI input jack on the TV.
Notes:
HDMI connection is required. Cables are not included. Analog connection is not supported.•
Do not tilt the connector when inserting it into the HDMI jack, and make sure the shapes of the jack and the •
connector are matched.
When using a non-HDCP compatible TV, the image will not display properly.•
An HDMI cable carries both video and audio signals. If you want to use TV speakers, you do not need to make an •
additional audio connection if you are using an HDMI cable.
Point the remote control at the remote sensor
and press the buttons.
POWER
Distance: About 5 m from the front of the remote
sensor.
Angle:
About 30° in each direction of the front of the
remote sensor.