Filter
Top Products
25
Connections
Basic Setup
Introduction
Connecting to a TV equipped with component video inputs
If your TV has component video inputs, you can obtain pictures in better quality.
Connections
• Make the following setting.
On-screen display
Select
Page
“Audio out select” “Analog 2ch” page 38
Component video outputs/inputs
Some TVs or monitors are equipped with component
video inputs. Connecting to these inputs allows you to
enjoy higher quality picture playback.
Actual labels for component video inputs may vary
depending on the TV manufacturer. (ex.Y, R-Y, R-B or
Y, C
B, CR)
In some TVs or monitors, the color levels of the
playback picture may be reduced slightly or the tint
may change. In such a case, adjust the TV or monitor
for optimum performance.
To switch the output signal (Progressive/Interlaced)
Press PROGRESSIVE on the remote control.
The output signal alternates between
component progressive and component
interlaced.
Notes
• Refer to the owner’s manual for the TV to be connected to this recorder for more information concerning an audio system.
• If you place the recorder near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the recorder
away from the tuner and radio.
• The output sound of the recorder has a wide dynamic range. Be sure to adjust the audio amplifier’s volume to a moderate
listening level. Otherwise, the speakers and your hearing may be damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the recorder’s power cord. If you leave the amplifier power on, the
speakers may be damaged.
To PR COMPONENT OUTPUT
To PB COMPONENT OUTPUT
To Y COMPONENT OUTPUT
To Y video input
To P
B video input
To P
R video input
TV or monitor equipped with
component video (INTERLACED/
PROGRESSIVE) inputs
Video cable
(not supplied)
PROGRESSIVE
Only video signals are output from
the COMPONENT OUTPUT jacks.
(Audio signals are not output.)
To obtain the sound, connect an audio
system to the audio output jacks.