Filter
Top Products
45
Introduction
Connections
Basic Setup
Setting up the remote control
5
While pressing , press 2.
The remote control mode is set to ‘“DR 2”.
Select the same mode that you have set to the recorder.
Notes
• If the recorder’s mode and the remote control’s mode are different, the recorder’s mode (DR 1, DR 2 or DR 3) appears in the
display of the front panel.
• When the batteries of the remote control are replaced or when the time indicator of the front panel flashes, check the remote
control modes of both the recorder and the remote control, and re-program if necessary.
Disabling the remote control for a temporary period
You can temporarily disable the reception of the remote control signals at the recorder, when the selection of DR 1,
DR 2 and DR 3 is not sufficient while you are using several Toshiba DVD video recorders.
Press the CH buttons on the recorder at the same time for three seconds or more.
The recorder display shows “DR - OFF”, indicating that the remote control is disabled.
To enable the remote control, perform the same step again. (The display shows “DR-1”, “DR-2” or “DR-3” depending
on your setting.)
Note
• This function is available while the recorder is turned on.
When using with DR 1
mode
When using with DR 2
mode
When using with DR 3
mode
2
DR 1
DR 2
DR 3
DR 1
DR 2
DR 3
DR 1
DR 2
DR 3
Remote controlRecorder
Mode setting
+
+
+
1
2
3
ANGLE
DISPLAY
FL SELECT
DIMMER
SUBTITLE
AUDIO/SAP
FREEZE
REMAIN
REC MODE
EXTEND
SETUP
VOL CH
TIMESLIP
INPUT SELECT
MUTE
MENU
TV
DVD
EASY
NAVI
INSTANT
REPLAY
INSTANT
SKIP
TOP MENU
QUICK MENU
SKIP REV STOP SKIP FWD
FWDPLAYREV
REC
SEARCH
T
ADJUST
CHP DIVIDE
ZOOM
PROGRESSIVE
1
2
3
4
5
6
+
10
0
SELECT/
ENTER