Filter
Top Products
28
After all the necessary connections,
• Turn on the equipment connected to the
recorder.
• Select the corresponding video input on
your television.
Perform these selections whenever you operate
the recorder.
Turning the power on
Press the ON/STANDBY button from the remote
control or on the front panel of the recorder.
When the power turns on, the LED on the front panel
illuminates.
After a few seconds, a startup screen appears.
The following icon will appear on the top right corner
of the screen. The icon will continue flashing
momentarily.
While the icon is flashing, the recorder is checking
the status and reading data of the DVD drive for
startup. If the DVD drive does not contain a disc,
the recorder consumes less time to startup,
because it does not need to read data from the
DVD drive.
While the “Loading” icon is flashing, the recorder
cannot respond to any operations. Operate after the
icon has disappeared.
Note
• When the recorder is turned on for the first time, the
following menu will be displayed after the “Loading” icon
has disappeared. See “A: Initial settings” ( page 30).
Turning the power off
Press the ON/STANDBY button from the remote
control or on the front panel of the recorder.
The “Unloading” icon appears on the right corner of
the top of the screen, and the LED turns off if it is
lighted. Then the power turns off.
Note
• If the recorder freezes for about 15 minutes and will not
respond to any buttons, holding down the ON/STANDBY
button on the front panel for about 10 seconds can force
the recorder to turn off. However, this is an emergency
measure, which contains a risk of damage to data or discs.
Avoid casual use of this measure.
Basic Setup
Starting up the recorder
Loading
e.g.
SETUP
e.g.
TV/Cable
Channel setting
TV
Initial settings
Language
Time & Date setting
English
Manual
OPEN/CLOSE
ANGLE
DISPLAY
FL SELECT
DIMMER
SUBTITLE
AUDIO/SAP
FREEZE
REMAIN
REC MODE
EXTEND
SETUP
VOL CH
TIMESLIP
INPUT SELECT
MUTE
MENU
EASY
NAVI
TOP MENU
ZOOM
PROGRESSIVE
ON/STANDBY button
LED
ON/STANDBY button