Filter
Top Products
NOTICE
PREPARATION
INTRODUCTION
RECORDING
OPERATION
PLAYBACK
OPERATION
RECORDING
1
Turn on the power for this VCR as well as associated
devices of the surveillance system including the video
camera and monitor TV.
5
Insert a video cassette to this VCR.
• Check that the safety tab on the video cassette has
not been removed.
2
Adjust the monitor TV so that the picture from the
video camera is displayed properly.
3
Check that the date time display on the monitor TV is
correctly displayed.
123
8/28/97 THU
17:30:05
SP
A 2
123
4
Set the various functions such as timer recording,
alarm recording, restart recording, tape end, etc.
6
Select the recording time mode.
7
Press the REC button.
Notes:
When the PAUSE button is pressed during recording, the VCR goes to the pause mode. To release, press either the PAUSE
button again or the REC button. If the VCR is in pause mode for longer than 10 minutes the VCR will automatically go into stop
mode to protect the video tape and heads.
Repeat recording, restart recording, alarm recording, etc. also operate during recording.
When recording is interrupted or the recording time is changed, the pictures may be disturbed at that location.
If a power failure should occur, it is possible to resume recording in the same time mode as long as the power is restored within
approximately 10 days.
During repeat recording, pay attention to the following points.
• Timer recording and alarm recording is not possible during automatic rewind.
• The buzzer does not sound even at tape end.
• When an operation button is pressed during automatic rewind, the repeat recording function does not operate. Reset to the
recording mode.
The time mode button is not accepted during alarm recording or timer recording.
Make sure to carry out daily check for repeat recording or timer recording.
RECORDING OPERATION
REC
H
SP
REC
H
SP
TIMER
POWER
EJECT
VIDEO MODE
TAPE REMAIN
TIME LAPSE VCR
4Head 960Hour
DISPLAY
TIME MOD
SET
SHIFT
COUNTER
ALARM RESETMEMORY
AUTO B/W
COLOR
REMOTE
OFF REMOTE OPTION
BUZZER
ON OFF
REC
REC CHECK
–
PICTURE
SOFT SHARP
TIME MODE
SET
+–
REC
23