Filter
Top Products
NOTICE
PREPARATION
INTRODUCTION
RECORDING
OPERATION
PLAYBACK
OPERATION
INSTRUCTIONS IN BRIEF
Front Panel
5
1
POWER button
Press to turn the power ON and OFF.
2
REC CHECK button
Press this button while in record mode to check the picture
that was just recorded. After an approximate 2 second
playback the VCR automatically goes back into record
mode.
3
TIMER button
Press this button to set the VCR in timer recording mode.
4
REC button
Press to set the VCR in record mode.
5
EJECT button
Press to eject the cassette automatically from the cassette
compartment.
6
VIDEO MODE switch
In the event of a weak color signal or insufficient S/N ratio,
set this switch to the appropriate setting (color or B/W).
AUTO : Automatically switches the circuit according
to the input signal or playback signal.
COLOR : Forcibly switches the circuit to color mode.
B / W : Forcibly switches the circuit to black and
white mode.
Note:
Regardless of what position the VIDEO MODE switch is in,
the EE output signal is the same as the input signal.
7
REMOTE switch (mode lock)
OFF : Set for normal operation.
REMOTE : Set for use with optional module connected
onto rear panel. This will lock the front
panel. Set switch to this position for mode
lock.
OPTION : Set for external operations when you use an
option module connected onto rear panel.
When switch is set to this position, the front
panel will be operationally limited. (See the
Instruction Manual supplied with the optional
module.)
8
BUZZER switch
This is the on/off switch for the buzzer. The buzzer sounds
continually when dew condensation is detected, when the
VCR starts alarm recording, and when recording reaches
to tape end. The buzzer beeps five times with a record-
protected cassette being inserted when REC button or
TIMER button is pressed.
The buzzer sound may be cancelled by setting this switch
off.
9
COUNTER MEMORY button
• Press once to set “COUNT. M” (counter memory) on the
VCR DISPLAY. The tape stops at a count of “0000” in
fast-forward mode or rewind mode.
• Press twice to set “ALARM M” (alarm memory) on the
VCR DISPLAY. The tape stops automatically at the first
alarm event detected in fast-forward mode or rewind
mode. Then the VCR is set to playback after still mode.
• Press three times to cancel this function.
p
COUNTER ALARM button
Press to display the tape counter or the alarm counter on
the VCR DISPLAY.
q
COUNTER RESET button
• Press to reset the tape counter to “0000” while in the
tape counter mode.
• Press to reset the alarm counter to “A-00” while in the
alarm counter mode.
SHARP
+
TIMER
POWER
EJECT
VIDEO MODE
TAPE REMAIN
TIME LAPSE VCR
4Head 960Hour
DISPLAY
PLAY
STOP REV FWD
TIME MODE
SET
SHIFT
TRACKING
LOCATION SELECT
COUNTER
ALARM RESETMEMORY
AUTO B/W
COLOR
REMOTE
OFF REMOTE OPTION
BUZZER
ON OFF
REC
REC CHECK
PAUSE/STILL
2 3 4
1 5
6 7
9 10 118
12 13 14 19 21 2216 18
15 17 20
–
VCR DISPLAY
PICTURE
SOFT
23