Filter
Top Products
35
Playback
Recording
Editing
Function setup
Others
Introduction
Library
To stop recording
Press STOP.
To pause recording (to omit an unnecessary
portion)
During recording, press PAUSE.
To resume recording, press it again.
Note
• Pausing recording automatically creates a new chapter
division at that point.
To change a TV channel to be recorded
1) During recording, press PAUSE.
Recording pauses.
2) Press CHANNEL to change the channel.
3) Press PAUSE to resume recording.
To view a TV programme while recording
another
1) Start recording on this recorder.
2) Press the TV/DVR button.
3) Using the channel selector of the TV, select a
desired channel on the TV.
If you press the TV/DVR button again, you will
go back to the display that you are recording.
2
:
13
End time
e.g.
To record and play at the same time
To start recording while playing a disc
Stop playback, then select the other disc by
pressing the HDD or DVD button, and start
recording on that disc.
To play a disc while recording on another disc
Select the disc that is not being recorded by
pressing the HDD or DVD button, and start
playback on the disc.
Note
• During a dubbing job, the unoccupied drive is available for
recording or playback, however, cannot perform a function
which records and plays simultaneously.
To set an end time of a recording which is in
progress
1) During recording, press QUICK MENU.
The Quick Menu appears.
2) Press
/ to select “End time” then press
ENTER .
The display changes as follows:
3) Press
/ to select an item then press
ADJUST to change the value.
4) Press ENTER.
Notes
• By setting an end time, it is memorized as a programmed
one, and the indicator in the front panel display
illuminates to indicate that the recorder holds a timer
program of recording.
• The programmed end time must be set for 5 minutes later
than the current time.