Toshiba RD-XS32SU DVD Recorder User Manual


 
12
Introduction
Preparation of the remote control
Operating with the remote control
Point the remote control at the remote sensor and
press the buttons.
Distance: About 7 m (23 ft) from the front of the
remote sensor
Angle : About 30° in each direction of the front of
the remote sensor
* Do not expose the remote sensor of the recorder to a
strong light source such as direct sunlight or other
illumination. If you do so, you may not be able to
operate the recorder via the remote control.
Notes
Direct the remote control at the remote sensor of the
recorder.
Do not drop or give the remote control a shock.
Do not leave the remote control near an extremely hot or
humid place.
Do not spill water or put anything wet on the remote control.
Do not disassemble the remote control.
1
Open the cover.
2
Insert batteries (AAA size).
Make sure to match the + and on the
batteries to the marks inside the battery
compartment.
3
Close the cover.
Notes on batteries
Improper use of batteries may cause battery leakage and
corrosion. To operate the remote control correctly, follow the
instructions below.
Do not insert batteries into the remote control in the wrong
direction.
Do not charge, heat, open, or short-circuit the batteries. Do
not throw batteries into a fire.
Do not leave dead or exhausted batteries in the remote
control.
Do not use different types of batteries together, or mix old
and new batteries.
If you do not use the remote control for a long period of
time, remove the batteries to avoid possible damage from
battery corrosion.
If the remote control does not function correctly or if the
operating range is reduced, replace all batteries with new
ones.
If battery leakage occurs, wipe the battery liquid from the
battery compartment, then insert new batteries.
Within about 7 m (23 ft)
30°
30°
LIBRARY
REC MENU EDIT MENU
CONTENT MENU
V-REMOTE
ANGLE
OPEN/CLOSE
SUBTITLE
AUDIO
CHANNEL
INSTANT SKIPINSTANT REPLAY
TOP MENU
MENU
RETURN
DVD
TIMESLIP
S
K
I
P
S
L
O
W
DVDHDD