Filter
Top Products
8
Introduction
Front panel
Rear panel
Identification of controls
See the page in for details.
9
E
FL display
The display may vary depending on the types of discs you play.
DVD video disc Audio CD
Some discs may not display elapsed
time.
• During playback:
Example
• During playback:
Example
Playing track 6
Video CD
• During playback:
Example
Playing track 1
Some discs may not display track
numbers or elapsed time.
ALL
REPEAT
AB
DVD CD
DVD indicator (DVD)
TRACK indicator (TRACK)
Message or number indicator
(Title, chapter, track, playing time or other information)
Play indicator ( )
Pause indicator ( )
Repeat mode indicators
(ALL REPEAT, REPEAT, REPEAT A B)
CD indicator (CD)
TRACK
DVD
CD TRACK
Some discs may not display track
numbers or elapsed time.
10
Introduction
Identification of controls (continued)
The instructions in this manual describe the functions on the remote control. See the page in for details.
MENU button
Use the MENU button to display the menu
included on many DVD video discs.
To operate a menu, follow the instructions
in “DVD menu.”
23
Remote control
11
E
Slide the battery compartment cover in the
direction of the arrow.
1
Operating with the remote control
Point the remote control at the remote
sensor and press the buttons.
Distance:Approx. 7 m from the front of the remote
sensor
Angle: Approx. 30° in each direction of the front of
the remote sensor
* Do not expose the remote sensor of the DVD video
player to a strong light source such as direct sunlight
or other illumination. If you do so, you may not be able
to operate the DVD video player via the remote
control.
Notes on the remote control
• Direct the remote control at the remote sensor of the DVD
video player.
• Do not drop or give the remote control a shock.
• Do not leave the remote control near an extremely hot or
humid place.
• Do not spill water or put anything wet on the remote control.
• Do not disassemble the remote control.
• When using the remote control, press the button at intervals
of approx. 1 second to ensure the correct mode of operation.
2
3
Loading batteries
Within approx. 7 m
Install two “R03/AAA” batteries (supplied), paying
attention to the polarity diagram in the battery
compartment.
Replace the compartment cover.
Notes on batteries
Improper use of batteries may cause battery leakage and
corrosion. To operate the remote control correctly, follow the
instructions below.
• Do not insert batteries into the remote control in the wrong
direction.
• Do not charge, heat, open, or short-circuit the batteries. Do
not throw batteries into a fire.
• Do not leave dead or exhausted batteries in the remote
control.
• Do not use different types of batteries together, or mix old
and new batteries.
• If you do not use the remote control for a long period of time,
remove the batteries to avoid possible damage from battery
corrosion.
• If the remote control does not function correctly or if the
operating range becomes reduced, replace all batteries with
new ones.
• If battery leakage occurs, wipe the battery liquid from the
battery compartment, then insert new batteries.