Filter
Top Products
ENG-14
Choosing a Connection
The following shows examples of connections commonly used to connect the DVD player with a TV
and other components.
Before Connecting the DVD Player
- Always turn off the DVD player, TV, and other components before you connect or disconnect any
cables.
- Refer to the user’s manual of the additional components (such as a TV) you are connecting for
more information on those particular components.
Connection to a TV (Video)
1
Using video/audio cables, connect the VIDEO (yellow)/AUDIO
(red and white) OUT terminals on the rear of the DVD player to
the VIDEO (yellow)/AUDIO (red and white) IN terminals of
your TV.
2
Turn on the DVD player and TV.
3
Press the input selector on your TV remote control until the
Video signal from the DVD player appears on the TV screen.
Note
- Noise may be generated if the audio cable placed too close to the power cable.
- If you want to connect to an Amplifier, please refer to the Amplifier connection page. (See pages 20 to 22)
- The number and position of terminals may vary depending on your TV set. Please refer to the user's manual
of your TV.
- If there is one audio input terminal on the TV, connect it to the [AUDIO OUT][left] (white) terminal of the DVD
player.
- If you press the V.OUT button when DVD Player is in stop mode or no disc is inserted, the Video Output
mode changes in the following sequence: (
COMPOSITE/S-VIDEO ➝ COMPONENT(I-SCAN) ➝
HDMI/COMPONENT(P-SCAN)
)
If HDMI/COMPONENT(P-SCAN) mode is selected and your TV does not support HDMI or progressive scan,
you cannot see any picture. Press the V.OUT button until the picture can be seen on the screen.
- When the Video Output in Setup menu is set to HDMI/COMPONENT(P-SCAN), the Video and S-Video
Outputs do not work.
RED
WHITE YELLOW
RED WHITE YELLOW
Audio Cable
Video Cable
Connections
00873A-SD-6980SY-1 8/22/05 4:41 PM Page 14