Filter
Top Products
19
Connecting to a
n audio system and TV equipped with component video
inputs
Interlaced outputs/inputs(ColorStream
®
)
Some TVs or monitors are equipped with component video
inputs. Connecting to these inputs allows you to enjoy
higher quality picture playback.
Actual labels for component video inputs may vary depending
on the TV manufacturer.(ex.Y, R-Y, B-Y or Y,
C
B
, C
R
)
In some TVs or monitors, the color levels of the playback
picture may be reduced slightly or the tint may change.
In such a case, adjust the TV or monitor for optimum
performance.
Progressive outputs/inputs (ColorStream®Pro)
Some TVs or monitors are equipped with component video
inputs that are capable of reproducing a progressively
scanned video signal. Connecting to these inputs allow you to
view the highest quality picture with less fl icker.
Consumers should note that not all high defi nition television
sets are fully compatible with this product and may cause
artifacts to be displayed in the picture. In case of
480
progressive scan picture problems, it is recommended that the
user switch the connection to the
"standard defi nition" output.
If there are questions regarding our TV set compatibility with
this model
480p DVD player, please contact our Customer
Service Center.
■ Before switching interlace video output
to progressive scan, be sure to set "Video
Output" to "Y P
B
P
R
")
You can temporarily switch the output signal for
better picture quality.
Press PROGRESSIVE on the remote control
during stop.
Notes
Refer to the owner’s manual of the connected equipment as well.
When you connect the DVD video player to other equipment, be sure to turn off the power and unplug all of
the equipment from the wall outlet before making any connections.
If you place the DVD player near a tuner or radio, the radio broadcast sound might be distorted. In this case,
place the DVD video player away from the tuner and radio.
The output sound of the DVD video player has a wide dynamic range. Be sure to adjust the receiver’s
volume to a moderate listening level. Otherwise, high volume sound may damage your hearing as well as
the speakers.
Turn off the amplifi er before you connect or disconnect the DVD video player’s power cord, if you leave the
amplifi er power on, the speakers may be damaged.
Analog audio out will not have sound DTS playback.
Audio system
To P
R
VIDEO
OUT
To P
B
VIDEO
OUT
To
Y
VIDEO
OUT
To ANALOG AUDIO OUT
(white)
(red)
(white)
(red)
To audio inputs of
the amplifi er
To Y video inputs
To
P
B
video inputs
To
P
R
video inputs
To wall outlet
TV or monitor with com-
ponent video inputs
On-screen display Select: Page
"Digital Output"
"Bitstream"
or
"PCM"
56
60
"Video Output"
Y P
B PR
59
● Making the following setting.
Signal Flow
Cables are not supplied
Connections